Tired of changing the seals for the Airforce Valves, we now have a solution for you.
The “Airforce Custom SS NPT Fill Nipple M3 Return Valve at Base” will replace the factory fill nipple found on most spin loc tank valves for the Airforce and Gunpower Airguns.
Made from SS to last and will never rust.
This fill nipple is designed to fill the tank slowly and will outlast the factory seals which are prone to frequent replacement.
IMP Note: Make sure your tank has been completely degaussed before you begin with the replacement.
Just unscrew the existing fill nipple from your valve along with the NRV and install our valve with fill nipple.
Do remember to clean off the teflon tape from the female threads on your valve from the factory installation.
Apply teflon tape on these threads as they are 1/8 npt threads and they seal off with the teflon tape.
You do not have to screw them all the way in, just 4 to 5 threads and you should be good to go.
The “Airforce Custom SS NPT Fill Nipple M3 Return Valve at Base” should not bottom out while installation for it to function properly.
Contact us if you need any customization and we shall be happy to get it done for you.
If you have any further query about the listed product you can use the above link to “Ask a Question”