Extreme-Flow Valve with Assembly Gen 2 Kit is our latest and innovative design.
Highlights:
Features burst disk for safe fill pressures.
Now comes with gauge and male foster fill so you can monitor the air pressure.
Innovative body which will prevent the valve from loosening as its designed to fit frames better.
(For spin-loc model Airforce and Gun Power frames only)
Foster fill for tethered shooting off your high powered airforce rigs as these consume excess air.
Don’t bother about the few shots and get worked up about the top up.
Our custom valves are very consistent shot to shot due to the unique design in the ports.
(Do read further for the recommended fill pressure and shot count.)
First of its kind designed and released in September 2017 by PCP Tunes.
These were built for those seeking extreme power with the .25 slugs, casts, round balls etc.
We recommend the projectile to be 60 grains and above for best performance.
These valves use a lot for air for their extreme performance.
Larger the capacity of the tank, higher the number of shots and more consistent results.
If you have your own tank with M18 x 1.5 threads, then it would be a direct fit.
Note:- The "Extreme-Flow Valve with Assembly" is for those who are using slugs, casts, round balls etc in .25 configuration on the Airforce Condor and Gunpower SSS
If you are using heavy pellets in .25 cal then our "Hi-Flow Valve with Assembly" is all you need.
The "Extreme-Flow Valve with Assembly Gen 2" will drive pellets at sub sonic speeds and could cause loss in accuracy.
The "Hi-Flow Valve with Assembly" drives the 43gr eun jins in the 1100 fps range to lower 1000.
This Extreme-Flow Valve does ship with a custom hammer spring and replaces the factory hammer spring to obtain better results.
You would have to increase the hammer weight so we've discounted the price for the hammer and added it as a combo.
You may choose whichever hammer you would like to have, Steel or Brass.
Kindly mention it in the notes when the order is placed.
If you forget to mention we will ship whichever we have in stock.
We have tested both the hammers on this valve and the results are outstanding so do not worry about the performance.
(Older version of Extreme Valves)
The best tested performance for this valve is from 3650 PSI to 2900 PSI (Make sure your bottle supports this pressure)
(Newer version of Extreme Valves)
Tested performance for the newer extreme flow valve is from 2800 PSI to 1500 PSI.
The valve can easily handle 3650 psi, but the initial shots are going to be at less power when filled to 3650 psi.
(NEVER FILL ABOVE THE WORKING PRESSURE OF YOUR TANK OR VALVE) (LOWER WORKING PRESSURE TAKES PRECEDENCE)
So, we recommend filling to the best tested performance of 2800 psi on these newer valves.
The order ships with the below 4 items and the price listed is for the combo:
1) Extreme Flow Valve with Assembly Gen 2
2) Airforce Extreme-Flow Valve Spring
3) Either one of the below hammers.
Extra Heavy Steel Hammer (110 g) Ver 2
OR
Extra Heavy Brass Hammer (115 g) Ver 2
4) Knurled Breech Black Knob Ver 1
BE SURE TO READ THE DOC FOR INSTALLATION WHICH IS SENT ON EMAIL BEFORE YOU BEGIN THE UPGRADES.
Contact us if you need any customization and we shall be happy to get it done for you.
If you have any further query about the listed product you can use the above link to “Ask a Question”
Name | |