Can be installed on our "Buddy Bottle - BARE - 500cc 250BAR M18 x 1.5 Thread" for better results when compared to standard tanks.
These valves use a lot for air for their extreme performance.
Larger the capacity of the tank, higher the number of shots and more consistent results.
If you have your own tank with M18 x 1.5 threads, then it would be a direct fit.
Note: The "Extreme-Flow Valve with Assembly" is for those who are using slugs, casts, round balls etc in .25 configuration.
If you are using heavy pellets in .25 cal then our "Hi-Flow Valve with Assembly" is all you need.
The "Extreme-Flow Valve with Assembly" will drive pellets at sub sonic speeds and could cause loss of accuracy.
The "Hi-Flow Valve with Assembly" drives the 43gr eun jins in the 1100 fps range to lower 1000.
Send us an e-mail us if you are still not sure or need to know more.
This Extreme-Flow Valve does ship with a custom hammer spring and replaces the factory hammer spring to obtain better results.
You would have to increase the hammer weight, so we've discounted the price for the hammer and added it as a combo.
You may choose whichever hammer you would like to have, Steel or Brass.
Kindly mention it in the notes when the order is placed.
If you forget to mention we will ship whichever we have in stock.
We have tested both the hammers on this valve and the results are outstanding so do not worry about the performance.
The best tested working pressure for this valve is from 3650 PSI to 2900 PSI (Make sure your bottle supports this pressure)
The order ships with the below 5 items and the price listed is for the combo :
1) Extreme Flow Valve with Assembly
2) Airforce Extreme-Flow Valve Spring
3) Either one of the below hammers:
Extra Heavy Steel Hammer (110 g) Ver 2
OR
Extra Heavy Brass Hammer (115 g) Ver 2
4) Knurled Breech Black Knob Ver 1
5) AirForce Refill Adapter Male Quick-Disconnect V3
Above fill adapters are a must to fill these extreme valves.
Standard fill adapters will bottom out on the extreme valves and you may not be able to disconnect the valve after filling air from scuba or hill pump.
(Creates a valve lock)
BE SURE TO READ THE DOC FOR INSTALLATION WHICH IS SENT ON EMAIL BEFORE YOU BEGIN THE UPGRADES.
Contact us if you need any customization and we shall be happy to get it done for you.
If you have any further query about the listed product you can use the above link to “Ask a Question”