Proud to launch our Gen 2 Newer Design Hi-Flow Valve Assembly with Fill Nipple and Gauge from PCP Tunes.
· Working pressure up to 250 BAR (3625 PSI).
· Newer innovative design (First of its Kind).
· No tools required for maintenance.
· Change o-rings of the manometer and fill nipple without any tools.
· Top Hat machined from single piece of steel for better consistency and performance.
· No adjustments required.
· Power enhancement up to 40% more than factory valve, involves hammer upgrade.
· Build from sturdier metals to outlast factory valve.
These valve assemblies have been designed and tested to work at pressures upto 250 BAR (3625 PSI).
Accurate 250 BAR gauges have been added to provide precise tank pressure readings.
Burst disk has been installed to ensure safety factor while working at higher air pressures.
We've added a Foster Fill Nipple which would help you top up the tank without having to remove the buddy bottle from the frame.
We highly recommend this valve assembly installed on our listed "Buddy Bottle - BARE - 500cc 250BAR M18 x 1.5 Thread" for best results.
Note:- This "Hi-Flow Valve with Assembly Gen 2" is only compatible with Spin-Loc frames or for older frames, post upgrading to Spin-Loc Collar.
Don't sweat if you have an older frame without the Spin-Loc collars. We have the parts you need for the upgrade. You could buy the "Spin-Loc Conversion Kit" from us. Post upgrading your older frames with the conversion kit you could use these "Hi-Flow Valve with Assembly Gen 2". The valve assemblies are not just upgrades in terms of foster fill and more accurate and durable gauges. They juice out 50% more energy that the max factory setups. Send us an e-mail us to know more.
Whenever at doubt, kindly drop us an email.
If using a Scuba Tank to fill the tank make sure you fill air slowly for the Foster Fill Nipple on the Hi-Flow Valve Assembly to operate as desired.
Use either of the below hammers for best performance.
Heavy Brass Hammer (95 g)
Heavy Steel Hammer (90 g)
Anything higher would be an overkill for the Hi-Flow Valve and would cause damages to the Valve.
For this upgrade you need to be using the factory main spring, DO NOT UPGRADE TO HEAVIER SPRING as the heavier hammer and an UPGRADED HEAVIER SPRING WOULD DAMAGE THE VALVE.
The Extra Heavy Hammers are only recommended for the Extreme Valves.
Warranty : Replacement warranty up to 12 months if the product fails.
Contact us if you need any further customization and we shall be happy to get it done for you. Click Here --->> Contact Us