Hi-Flow Valve with Assembly comprise of our custom PCP Tunes Valve, helps increase the output and provide consistent shots.
These are now available in shorter version, highly recommended when you purchase our airforce regulators.
They provide more room in the plenum and help achieve higher velocities and power.
These valve assemblies have been designed and tested to work at pressures up to 250 BAR (3625 PSI).
Pic shows dead end plugs on the valve assembly, they are not needed when you have our regulators.
Our regulators have a dual gauge which shows you the regulated pressure (pressure in the plenum) and the fill pressure (pressure in the main tank).
The regulator also has a male qd style fill nipple which is used to fill air.
Post upgrade, the gauge on the valve assembly and the fill nipple are of no use so they have been shut with dead end plugs.
Newer models would not have the dead-end plugs as they increase the machining process and add no value when used in conjunction with our airforce regulators.
Newer models would also allow you to position the gauges and fill nipple correctly wherever you would want it set.
(The new feature will work for both spin loc and non-spin loc models)
(However, the adjustability options prevail for those frames which have the spin loc collar frame)
Burst disk has been installed to ensure safety factor while working at higher air pressures.
We highly recommend “Hi-Flow Valve with Assembly" installed on the "Buddy Bottle - BARE - 500cc 250BAR M18 x 1.5 Thread" for best results.
Current Model Shown: This "Hi-Flow Valve with Assembly Gen 2 Short Version" is only compatible with Spin-Loc frames or the newer model Airforce Frames.
Do not sweat if you have an older frame without the Spin-Loc collars. We have the parts you need for the upgrade.
You could buy the "Spin-Loc Conversion Kit" from us. Post upgrading your older frames with the conversion kit you could use these.
The valve assemblies do juice out 50% more energy that the max factory setups. (Along with the heavier hammer)
MODEL CHECK: FOR THE MODELS BEFORE 2019 ONLY. (OLDER AND NEWER FRAMES)
Contact us if you need any customization and we shall be happy to get it done for you.
If you have any further query about the listed product you can use the above link to “Ask a Question”