"Hi-Flow Valve with Assembly" comprise of our custom PCP Tunes Valve, helps increase the output and provide consistent shots.
These valve assemblies have been designed and tested to work at pressures upto 250 BAR (3625 PSI).
We have received several requests for the hotter valves without the gauges and fill nipple as they retain the take down platform of the Airforce and Gunpower airguns.
Spin Loc tanks with gauges are great for plinking sessions.
When you are on the go and want to have a takedown configuration, nothing better than these valves.
Burst disk has been installed to ensure safety, as these work at higher air pressures.
Safety and performance is our prime responsibility. All assemblies are filled to 250 bar and tested for leaks before being shipped out to customers.
We highly recommend having the "Buddy Bottle - BARE - 500cc 250BAR M18 x 1.5 Thread" with these valves as you can fill them to 3625 psi for best results.
They valves do juice out 50% more energy that the max factory setups. Send us an e-mail us to know more.
Use either of the below hammers for best performance.
Heavy Brass Hammer (95 g)
Heavy Steel Hammer (90 g)
Anything higher would be an overkill for the Hi-Flow Valve and would cause damages to the Valve.
For this upgrade you need to be using the factory main spring, DO NOT UPGRADE TO HEAVIER SPRING as the heavier hammer and an UPGRADED HEAVIER SPRING WOULD DAMAGE THE VALVE.
The Extra Heavy Hammers are only recommended for the Extreme Valves.
Whenever at doubt, kindly drop us an email.
Note:- The newer assemblies do not come with dead end plugs for the fill port or the gauges. They only have burst disks installed for safety.
End plugs shown in picture were for the older model and have been discontinued.
Warranty : Replacement warranty up to 12 months if the product fails.
Contact us if you need any further customization and we shall be happy to get it done for you. Click Here --->> Contact Us